HACKberry sometimes has difficulty pinching objects because of its lack of friction.
Silicone rubber finger cap will be helpful in such situation.
3Dプリントで出力したままの指は摩擦がないので、
ものをうまく掴めない事があります。
シリコンゴム製のキャップをはめることで、
格段に使いやすくなります。
Make the cast data by offsetting the data of finger tip.
The picture shows an example.
The surface was created by 2mm offsetting original surface using Meshmixer.
If you want to try, please download the data from the following link.
指のデータをオフセットして型用のデータを作ります。
以下は一例ですが、Meshmixerを使って外観面を2mmオフセットして作りました。
試す場合は以下のURLからダウンロードして下さい。
https://drive.google.com/folderview?id=0B_O4N8Ng5KyZYU1XLS1rY25rc0E&usp=sharing
Apply releasing agent so that the silicon rubber will be ejected easily.
In this case, I use floor wax as releasing agent.
Add curing agent to silicon rubber and mix them.
Then, pour them to the cast.
Assemble the molds.
Remove overflowed silicon rubber before it gets stiff.
Fix the molds using clamp or tape.
テープやクランプを使って型を固定して下さい。
Let the rubber rest until it gets stiff.
Curing time is depend on the material you use.
ゴムが硬化するまで放置して下さい。
硬化時間は使用するゴムによって決まります。