Hackberry portal › Forum › HACKberry › Q&A › ARM socket for boil water This topic contains 2 replies, has 2 voices, and was last updated by Hiroshi Yamaura 4 years ago. Viewing 3 posts - 1 through 3 (of 3 total) Author Posts 2016-05-23 at 5:29 pm #1005 MoldiTux TuxtepecParticipant I am creating a socket for print in a plane . Only in PLA, i will upload the archive in f3d. I need any help in create a better transition in the curve . [img]http://i.imgur.com/fNDL2QN.jpg?1[/img] https://mega.nz/#!xlk3BBZI!8oHw3y5lY7BfSsG877yxW_f67uHjGCGFChOPKjwXEkg 2016-05-23 at 5:30 pm #1006 MoldiTux TuxtepecParticipant 2016-05-23 at 9:39 pm #1007 Hiroshi YamauraKeymaster Hi, MoldiTux, I just tried to make it with Fusion 360 sculpt mode. View post on imgur.com View post on imgur.com You don’t need to use other storage service. You can share the data from Fusion 360 directly. Please check the data from the following link. http://a360.co/1TqrPQC This video shows how I made this data. http://autode.sk/1YRof0c However, I’m also not very good at using T spline. It would be appreciated if anybody could provide better data. This reply was modified 4 years ago by Hiroshi Yamaura. Author Posts Viewing 3 posts - 1 through 3 (of 3 total) You must be logged in to reply to this topic.