Hackberry portal Forum HACKberry Report percentage of filling model?

This topic contains 1 reply, has 2 voices, and was last updated by  Hiroshi Yamaura 2 years ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1166

    Pavel Krasnoyarov
    Participant

    Hello! what should be the percentage of filling model? The bigger, the better? Or possible to be limited to 30-50%?

    #1167

    Hiroshi Yamaura
    Keymaster

    We have not fix that specification.
    We usually use “big hole” in the UP! software.
    It may be 50% or less density.
    Most of parts are durable even if it is printed with this setting.
    However, if you have a trouble, please use higher density especially for smaller or thinner parts.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.